BENDER AMADA HFP 100-3L

Specifications:

• 100 tons (approx. 1000 kN.)
• Length of bent: 3000 mm.
• Measure between the uprights: 2700 mm.
• Mounting hight: 620 mm.
• Displacement: 350 mm.
• Subject of the tooling system using Wila hydraulic clamping device.
• 7 axis:
  • Axis X1, X2 (CNC):
    • Displacement 600 mm.
  • Axis Y1, Y2 (CNC):
    • Speed descendant Y: 220 mm/s.
    • Speed ascendant Y: 220 mm/s.
  • Axis Z1, Z2 (CNC):
    • Displacement 2400 mm.
  • Axis R (CNC):

BENDER TRUMPF TRUBEND 5130

Specifications:

• 130 tons (approx. 1300 kN)
• Length of bent: 3230 mm.
• Measure between the uprights: 2690 mm.
• Mounting hight: 615 mm.
• Displacement: 445 mm.
• Subject of the tooling system using TRUMPF hydraulic clamping device (Wila type).
• 10 axis:
  • Axis X1, X2 (CNC):
    • Displacement 600 mm.
    • Position accuracy: 0.04 mm.
    • Ground speed: 0 – 1000 mm/s.
  • Axis R1,R2 (CNC):
    • Discplacemenet 250 mm.
    • Position accuracy: 0.08 mm.
    • Ground speed: 0 – 330 mm/s.
  • Axis Z1, Z2 (CNC):
    • Displacement 2400 mm.
    • Position accuracy: 1.00 mm.
    • Ground speed: 0 – 1000 mm/s.
  • Axis Y1, Y2 (CNC):
    • Speed descendant: 220 mm/s.
    • Speed ascendant: 220 mm/s.
  • Axis V (CNC):
    • Pumping shaft with bureau of compensation. The pumping compensates for the deflection of the lower table and the top angle to get a regular on the entire surface of bent.
  • Axis I (CNC):
    • In the axis I, the lower fixture is adjusted on an ongoing basis using a unit of linear positioning. With this option you can directly activate any position desired. In this way can be applied quickly and easily both the standard tools such as the specials.

BENDER MEBUSA RG 30-12A (2 unidades)

Specifications:

• 30 tons (approx. 300 kN)
• Length of bent: 1250 mm.
• Measure between the uprights: 1020 mm.
• Mounting hight: 300 mm.
• Displacement: 100 mm.
• Speed descendant: 80 mm/s.
• Equipped with numerical control model MECOS LSH/420/30/1250 driven by the programr DG-202 (2 axis).
• Pneumatic system COMBIMATIC.

BENDER MEBUSA RG 65-20

Specifications:

• 65 tons (approx. 650 kN)
• Length of bent: 2000 mm.
• Measure between the uprights: 1800 mm.
• Mounting hight: 300 mm.
• Displacement: 100 mm.
• Speed descendant: 80 mm/s.
• Equipped with numerical control model MECOS LSH/420/30/1250 driven by the programr DG-202 (3 axis).
• Pneumatic system COMBIMATIC.